ULTRON 1 HP Submersible Water Pump, Multicolour

By Brand : ULTRON

Avg Customer Reviews :

Installation Guide:- Topping up the motor. Position the motor vertically on its base. Then the two threaded plugs provided at the top/circumference of the cable box are removed. top up the motor with clear cold drinking water. The two threaded plugs are then re-assembled, ensuring the motor is encapsulated. Dry the exterior of the motor and check thoroughly for water leakage. If there is no leakage, the motor is ready for coupling with the pump and installation. Waterproofing the submersible motor cable. The free end of the 3-core cable of the motor needs to be connected to the supply cable from the control panel. As this joint is always nearly submerged in water, the joint needs to be waterproof. Coupling submersible motor to pump. Keep the submersible motor vertical. Coupling is fitted with motor shaft/pump shaft with a grub screw. Check the play in assembled condition by lifting the shaft. Ensure that studs on the motor top housing should pass through the holes in the bottom portion of the inlet bracket and that the face of the inlet bracket rests on the motor top housing. Install the pump set a minimum of 20 feet from the bottom of the Borewell. It is recommended that the Control Panel incorporate the following. Contactors of sufficient current ratings with an over-current relay. Over-voltage and under-voltage protection. Phase failure protection. Dry run preventer. Ammeter and Voltmeter to display current and voltage. Note That:- 1 HP Control Panel required. We are Providing Only Motor Pump Set.