Tiles Adhesives By TIELO

• This product will be an excellent pick for you
• It is made up of premium qualityMATERIALbr>
• This product comes in a proper packaging

• Grouting should not begin until the tile settingMATERIALis properly cured (a minimum of24 hours).
• Wipe the tile surface with a damp cloth before Grouting.
• Using a Float, trowel the mixed grout over the surface and into the grout oint, careful to assure all ioints are filled fully. Hold the float at a 450 angle to the surface of the File.
• As soon as possible, remove excess grout from the tile surface with float held at a 900 angle and moving diagonally across the joints. Strike the joint with theblunt end of a too-compacting the surface but not digging out the grout.
• Clean remaining grout from the tile surface as soon as grout firms up enough to be worked without being pulled from the joint by using a Scotch Bright Pad, or a pad of dampened cheese cloth or tile cleaner Under extreme heat or low humidity conditions, the foor should be covered with brown Kraft paper to retain moisture. Do not use polyethylene as it may resuit in uneven drying and discolored joints. The grouted foor must be protected from traffic for 72 hours after installation.