Power & Hand Tools By ACTINTOOL

• Fit with sds max rotary hammer & demolition hammerThis 5 inch bush hammer plate is packed with a 5/8\"-11 to SDS Max shank adapter, can fit with sds max rotary hammer or demolition hammer.
• Fit with polisher & speed ajustable angle grinderTaking away the adapter, the bush hammer plate can fit with 5/8\"-11 spindle polisher or speed adjustable angle grinder. Working speed less than 2000 RPM
• Wide Use1. Creates anti-slip finish on granite and marble 2. Remove hard coatings and overlays 3. Increase bonding effectiveness by preparing the concrete with CSP 4-5 roughness before the application of high build coating and overlays.
• Size5 inch plate, total length with shank 9 inch. 3 pcs rollers on a 5 inch plate, each roller is welded with 30 teeth.
• WarningRotaion mode only, no impact mode, which can twist the adapter shank. Working speed under 2000 RPM, do not operate with too much pressure, which can stop the roller from running and break the shank. Rollers and shank are sold separately in actintool store, you can buy to replace the worned parts.
• WarningFitting with rotary hammer, this bush hammer tool only works in rotary mode, the high speed and little pressure can make it dig not so deep, the estimated profile close to CSP 2-3. It is suggested to fit with polisher, low speed ( under 1000 RPM) higher pressure can make it dig deeper close to CSP 4-5.