Power Transmission Products By Anex

• Set torque prevents overtorque of screws
• Will not damage screws or base material
• Suitable for tightening circuit boards and torque management
• Use with a replacement handle or drill screwdriver. Impact driver cannot be used
• 7.2V or less drill driver recommended
• Set torque: 2.6 N?m (for M5 screws) accuracy 10%
• Total Length: 3.0 inches (75 mm), Maximum Diameter: 0.5 inches (12 mm)
• Shank Size: 0.25 inch (6.35 mm) diagonal axle, tip mounting size: 0.25 inch (6.35 mm) hex shaft
• Certificate of calibration is available for free (contact seller)
• Note: The set torque value is intended for use on a distribution board and may not be suitable for other applications