Robotics By Electrobot

• The result is excellent performance in a simple-to-use.
• This RF module comprises of an RF transmitter and an RF receiver.
• TX: Power supply and/or modulation input voltage : 2.2 to 5.5v. Operating temperature: -40 to +80C.
• RX: Power supply and/or modulation input voltage :.5v. Operating temperature: -20 to +80C.
• Specifically designed for remote-control and wireless security operating at 315/434Mhz.

• KY-026 Flame Sensor Module IR Sensor Detector
• Extremely sensitive to wave between 760-1100nm, Power Supply: 0-15 V DC
• Comparator chip LM393 makes module readings stable.
• Detection angle about 60 degrees, it is sensitive to the flame spectrum.
• Hole Inner Diameter: Approx. 3mm ; Size (L x W): Approx. 36 x 16mm

• It comes with Good Quality Gears.
• The metal gears have better wear and tear properties.
• Gearbox is sealed and lubricated with lithium grease and requires no maintenance.
• Although motor gives 100 RPM at 12V, motor runs smoothly from 4V to 12V and gives the wide range of RPM, and torque.
• The shaft has a hole for better coupling.

• DS3231 Module is a Bread Board friendly extremely precise I?C real time clock Module.
• DS3231 RTC and AT24C32 EEPROM integrated with temperature compensated crystal oscillator.
• Operating voltage :3.3 5 .5 V
• I?C bus interface, the maximum transmission speed of 400KHz (working voltage of 5V)
• Chip temperature sensor comes with an accuracy of ? 3

• High-performance wireless transceiver system.
• Wireless transceiver Sensitivity (Bit error rate) can reach -80dBm.
• Has a build-in 2.4GHz antenna; user neednt test antenna.
• Low power consumption.
• Has a 2.4GHz digital wireless transceiver.

• A detailed user manual/guidebook(PDF) with 25 lessons is provided.
• It is esay for you to learn UNO R3 Microcontroller and programming.
• Quick-responding technical support for free.
• Re-designed case, it is very beautiful, and it is a best gift for children.
• Arduino UNO R3 Microcontroller is included.

• Cable length: About 21.4 cm/ 8.4 inch (m/ m), 20.7 cm/ 8.1 inch (m/ f), 20 cm/ 7.8 inch (f/ f)
• Including: 1 x 40-pin m/ f jumper wires, 1 x 40-pin m/ m jumper wires, 1 x 40-pin f/ f jumper wires
• Can be separated into the assembly containing the wire quantity you required and to support non-standard odd-spaced headers, suitable for arduino breadboard kit project, pcb project, pc motherboard, etc., Through the pin connection, without welding, fit for fast circuit test
• available in multicolour

• Carbon film resistors, 50+ values
• Quantity: 1000 pieces (20 each)
• Tolerance: 5 percent, power rating: 0.25 watt
• weight: 370 gms
• good quality product

• Relative humidity and temperature measurement
• All calibration, digital output
• Excellent long-term stability
• Long distance signal transmission
• Low power consumption

• Micro Momentary Tactile Tact Touch Push Button Switch.
• Size: 6 x 6 x 5mm
• Temperature: -30 ~ +70 Centigrade
• Withstand voltage: AC250V
• Rated load: DC12V 50mA