Robotics By SCRIPTRONICS

• Pitch: 2.54mm with 40 Pin
• Material Type Copper and Plastic
• Best tools for arduino prototype shield
• Good for many applications include industrial, laboratory, personal and hobbies
• Great addition to your hobby craft tool kit. Perfect Product for your saftey and Lab Supply.

• Power supply: 3 5v
• Supply Current: 400uA
• Operation temperature: 40 Celsius 85 Celsuis
• Analog output communication interface
• Three-axis magnetic field accelerometer module

• Voltage input range: DC 0-25V
• Voltage Analog Resolution: 0.00489V
• Voltage detection range: DC 0.02445V-25V
• DC input connector: Terminal cathode connected to VCC, GND negative pole
• Output interface: \"+\" connect 5/3.3V, \"-\" connect GND, \"s\" connect the A_rduino AD pins

• Input Voltage: 5V-15V DC
• Output amplitude: 4.2V V-PP to 11.4V V-PP.
• Output Current : 15mA for 5V & 35mA for 12V.
• Working voltage: 5-12V
• Minimum 50% duty cycle, 3.7 Hz & Maximum 98% duty cycle, 1.3KHz

• Connect Type C cable for power, or 5V DC to pads marked IN+ and IN- on the left-hand side of the module
• Connect cell to charge to B+/B- pads on the right-hand side of the module.
• A load (something for the battery to power) can be connected to the OUT+/OUT- pads on the right-hand side
• Important! Disconnect load when charging
• The red LED indicates charging in progress, the green LED indicates charging has finished.

• Completely reusable
• Terminal Strips 630PTS
• Distribution Strips 200pts
• MB102 830 POINTS SOLDER LESS PCB BREAD BOARD PROTOTYPE BOARD
• ABS Plastic Completely reusable Coloured coordinates for easy component placement

• The interface is clear and simple, powerful, easy to understand, meet almost all our needs,
• Easy to use, Wide voltage power supply (6 ~ 30V) supports micro USB 5.0V power supply,
• There is a key stop function (STOP key), with reverse polarity protection, reverse polarity does not burn,
• Increase the sleep mode, it enables, without any operation within 5 minutes, turn off the monitor automatically, any key to wake up,
• You can set a different OP, CL, LOP parameters, which are independent of each other, were saved; All setup parameters are saved automatically power down.

• There is a normally open and one normally closed contact.
• The control DC or AC signal, you can control 220V AC load.
• Blue KF301 terminals to the control line is more convenient.
• With the power supply and relay instructions, pull off, disconnect does not shine.
• The module complies with international safety standards, the control area and the load region isolation trench.