Robotics By Super Debug

• Operating Voltage: 5V DC
• High sensitivity to LPG, natural gas, town gas.
• Small sensitivity to alcohol, smoke.
• Simple drive circuit.
• Fast response.

• PACKAGE CONTENT: 1 Ultrasonic sensor ,1 SG90 and 10 Pc Male to Female jumper wire
• This sensor kit is best suited for development boards compatible with arduino , Raspberry Pi and other microcontrollers.
• The ultrasonic sensor included in the kit is a HC-SR04 ultrasonic sensor which is used to measure the distance to an object.
• Jumpers Wires provided are of length 20 CM

• The module is based on a touch-sensing IC TTP223 capacitive touch switch module, it allows you to avoid the trouble of conventional push-type buttons.
• Modes: jog, self-locking
• Power Supply: 2V-5.5V
• Trigger setting mode:(1- Greater than Short;0- Greater than No Short)

• 104 % SATISFACTION GUARANTED Consistent hole alignment; Easy Pin Insertion; Refund if you are not happy without any reason
• NO WORRIES ABOUT CIRCUIT FAILIER Spend the better part of your time on Creativity and fun DIY rather than debugging the unknown frailer of the poor breadboards
• PIN HOLES ARE EXQUISITELY LINING UP Without any intermittent connections; Holes are properly cut out
• PERFECT SET FOR YOUR EXPERT PROTOTYPING A great combination for your needs; Snap together easily in groups; Excellent for Arduino Proto Shield
• PACKAGE COMPONENT 6 X 400 tie-points

• Differential input voltage: ?40mV
• Data accuracy: 24 bit
• Refresh frequency: 10/80 Hz
• Operating Voltage: 2.7V to 5VDC
• Operating current: <10 mA

• Driver chip: L298 dual H-bridge driver chip.
• Operates up to 35V DC
• Drive part of the peak current Io: 2A / Bridge
• Logical part of the terminal power supply range Vss :4.5V-5.5V
• Maximum power consumption: 20W

• Pitch: 2.54mm, number of pins: 40pin
• Made of copper and plastic
• Type of row: single row, type of pin: straight
• Great tools for arduino prototype shield
• Come with 20pcs male headers and 20pcs female headers

• The male ends meant for insertion into standard 0.1 inch (2.54mm) female sockets and the female ends are meant for insertion onto standard 0.1 inch (2.54mm) male headers
• Can modify or revise the circuits easily
• Each cable length about 20cm
• Reusable for fast build a prototype of an electronic circuit will accept transistors, diodes, leds, resistors, capacitors and virtually all types of components

• 400 Points Breadboard with 2 Positive & Negative Power Lines on both ends.Perfect for Arduino Shield Prototyping and Testing.
• Insertion Wire Size is 21 to 26 AWG, 0.016 to 0.028 inches diameter (0.4 to 0.7mm diameter),works with dupont jumper wires kit.
• White ABS body with black printed legend. Color legend on distribution strips.
• With self-adhesive tape on the back, make it easy to stick on the Arduino Prototype Shield.
• Good kits for Arduino breadboard kit proto shield and DIY projects.