Fasteners By SIMPSON

• 5-1/2-inch Length
• 16 Gauge Galvanized
• Use a Maximum of 1 Screw per Slot
• Provides a Full 1-inch of Both Upward and Downward Movement

• Install with Outdoor Accents structural screws and hex-head washer for a decorative look (sold separately)
• The Avant Collection features straight edges and chamfered corners for a clean, timeless design
• Dimensions: 8-1/4 in. x 8-1/4 in.
• Made from 12-gauge steel
• ZMAX galvanization with black powder coat offers extra corrosion resistance for exterior and treated-wood applications

• Thread design undercuts to efficiently transfer the load to the base material; qualified for static and seismic loading conditions
• Specialized heat-treating process creates tip Hardness for better cutting without compromising the ductility
• No special drill bit required - designed to install using standard-sized ANSI tolerance drill Bits
• Hex-washer head requires no separate washer, unless required by Code, and provides a clean installed appearance
• Cost-effective solution for less extreme applications where the environment may be wet, moist or damp

• easy to install

• Metal reinforced to provide greater holding power and increased pullover resistance
• Type 300 series stainless-steel plate ensures lasting durability in demanding environments
• Prevents over-driving of the screw, helping to ensure consistent, quality installations
• Angled screw attachment ensures direct attachment of the board to the joist
• Quantity: 100-pieces

• Nail stoppers help prevent nails from piercing pipes and electrical lines
• Install over utilities that pass through framing members
• 1-1/2 in. Width
• Made from 16 gauge steel
• Galvanized for extra corrosion resistance

• 20 EACH

• Trim head with nibs for easy countersinking
• #2 square drive (driver bit in each box; replacement bit model BIT2S)
• High-low threads
• Sharp point, curved collation

• Patented double-shear nailing design provides greater strength with fewer nails
• Speed prongs for fast and easy installation
• Angled joist nailing easier in tight spaces
• Made from 18 gauge steel
• Zmax galvanization offers extra corrosion resistance for exterior and treated-wood applications

• The strong-bolt 2 anchor received classification as a category 1
• Each segment adjusts independently
• Enables clip to undercut into the concrete
• The strong-bolt 2 anchor can be installed in cracked concrete with a minimum thickness of 3 1/4\"
• This special alloy clip offers improved performance

• easy to install

• One piece wrap around clip
• Threaded end is chamfered for ease of starting Nut
• Most sizes feature full Thread for added versatility

• CODE LISTED-Can be used in cracked or uncracked concrete
• LOW INSTALLATION TORQUE-Fast and easy to install; provides outstanding performance
• INDUSTRY LEADING PERFORMANCE-Can be used even in seismic conditions.
• THREAD DESIGN UNDERCUTS-Efficiently transfers the load to the base material.
• SPECIALIZED HEAT TREATING PROCESS-Creates tip hardness for better, faster cutting without compromising the ductility

• Deep 6-lobe recessed ribbed head provides clean countersinking and more secure bit retention for fewer cam-outs
• Redesigned tip and thread pattern provides easy starts and up to 25-percent less torque while driving, which results in up to 20-percent faster driving
• The holding power of WSV screws reduces the gaps between the joist and subfloor that cause floor squeaks
• WSV screws can be easily backed out, allowing for future access to floor cavities
• Yellow zinc coating; #9 x 1-3/4-inch; head diameter: 0. 333; includes: 6-lobe T25 drive bit

• Not designed for welded or nailer applications
• These hangers are designed for applications where higher loads are needed
• Nails must be driven at an angle through the joist or truss into the header to achieve the table loads