International Power Adapters By DZS ELEC

• Module Name: 12A DC Step Down Buck Converter
• Input Voltage: 4.5V-30V ; Output Voltage: 0.8V-30V( continuously adjustable ); Output Current: 0A-12A 100W ( Can be up to 200W if enhance heat dissipation )
• Short-circuit protection (14A MAX) combined with over-temperature protection (Automatically shut off the output once over temperature), safe and reliable.
• Coming with enhanced enhanced aluminum radiator make the work temperature is lower and more stable. 50V/MLCC chip capacitor, combined with high frequency low resistance electrolytic condenser, make the output ripple lower.
• TVS tube can effectively prevent surge breakdown voltage, make the work safer and more reliable.

• XL6009 DC-DC Adjustable Booster Power Converter Module, High efficiency non-isolated booster module can be used for booster voltage stabilizer power supply, DIY adjustable mobile power supply, booster charger, etc.
• Input Voltage: 3V-32V, The optimal operating voltage range is 5-32V; Output Voltage: 5V-35V Continuing Adjust (Step-up module, output voltage is higher than input voltage)
• Input Current: 4A (max) Non-Load 18mA (The higher voltage, the greater no-load current.)
• The booster power board is equipped with 4A high-efficiency MOSFET switch tube, with the conversion efficiency up to 94%.
• Ultra high switching frequency 400KHz, the filter capacitance with small capacity can achieve very good effect, smaller ripple and the volume.

• Mini 3A DC-DC Step-down power module, suitable for aviation model power supply, DIY mobile power supply, monitoring power supply, four-wheel-drive power supply, communication equipment power supply, etc.
• Wide Input Voltage Range: 4.5V to 28V, can be used as voltage regulator 24V/12V/9V to 12V/5V/3.3V etc.
• Output Voltage: 0.8V to 20V adjustable, 3A (max), Transfer Efficiency up to 96%.
• Working Temperature: -45 to 85 degrees Celsius, Size: 22x17x4mm. Be well-suited for all kinds of occasions with strict requirements for volume and weight.
• Note: Be careful not to reverse the positive and negative terminals to avoid any possible damage.