Cutting Tools By CLEVELAND

• High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
• Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
• Round shanks allow use with a wide variety of toolholding systems
• When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging
• Set includes 1/16 inches - 3/8 inches drill bits
• Made in the USA

• High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
• Steam oxide finish
• Round shanks allow use with a wide variety of toolholding systems
• Single flute
• Applicable for carbon steel and cast iron materials

• High helix angle for improved chip removal in soft materials and deeper holes
• 118-degree conventional point angles, for general drilling applications
• Uncoated (bright), for use with a wide range of drilling materials
• High-speed steel (HSS) for use on a wide variety of materials
• Jobber-length, for a wide range of applications
• Made in the USA