Cutting Tools By Festool

• Tungsten carbide tipped reversible straight bit
• Features 25 mm cut length and 55 mm overall length
• Measures 8 mm shank diameter and 10 mm cutting diameter
• Ideal for use with VS 600 FZ 10

• Re-sharpening the blunt blades of conventional bits not only costs time and money but also reduces the diameter of the bit. This is not a problem with carbide-tipped Duro-Form bits.
• Fast replacement of bits means sharp tools are readily available at all times.
• Guaranteed constant bit diameter, thanks to replaceable bits.
• Lower costs after purchase. One reversible bit lasts as long as two to four conventional bits and is thus extremely economical.
• The very hard-wearing reversible bits are exceptionally efficient, which means less cutting pressure is required and work is easier.

• For use with the Festool MFK 700 Trim Router, this router bit produces the perfect radius on 1mm wood or plastic edge banding
• The cutters can be rotated, prolonging service life with four new cutting surfaces
• Made in Germany

• Re-sharpening the blunt blades of conventional bits not only costs time and money but also reduces the diameter of the bit. This is not a problem with carbide-tipped Duro-Form bits.
• Fast replacement of bits means sharp tools are readily available at all times.
• Guaranteed constant bit diameter, thanks to replaceable bits.
• Lower costs after purchase. One reversible bit lasts as long as two to four conventional bits and is thus extremely economical.
• The very hard-wearing reversible bits are exceptionally efficient, which means less cutting pressure is required and work is easier.

• Tungsten carbide tipped drywall v-groove bit
• Features 16 mm cut length and 49 mm overall length
• It also features 90 degree cut angle
• Measures 8 mm shank diameter and 32 mm cutting diameter

• Tungsten carbide tipped spiral bit
• Designed to use for SZ 20 half-blind dovetail template
• Features 30 mm cut length and 60 mm overall length
• Measures 8 mm shank diameter and 10 mm cutting diameter

• Fits perfectly into Systainer? models with lid compartments
• Drills and bits are securely held in modules that can be flexibly moved
• Drills made from high-alloyed ball bearing steel
• With center point and two cutters for drilling quick and clean holes
• 2 chamfers instead of pre-cutting blades for an extended useful life, even when cutting laminated chipboard