Home Improvement Tools & Testers By BAOSHLA

• Powerful Functions Indicate the signal directions and power in fiber,displays the relative core power. Can detect optical signals in the tone signal fixed load,270Hz,1KHz and 2KHz,to identify a specific optical fiber,can quickly find the necessary fiber.
• Efficient and accurate Compact and practical, very easy to operate, low error detection and ins.
• Visual Fault Locator Build in 10mw VFL red light source can measure the fiber distance is about 10-15 kilometers.
• Optical Power Meter Build in OPM function,test wavelength 850/980/1270/1300/1310/1490/1550/1577/1625/1650nm,Measurement range -70~+10dB. Connectortype 2.5 universal connector.
• Widely Compatible 4-in-1 universal fixture. Applicable to 0.25 .9 .0 .0mm. No fixture replacement is required for online testing.

• Three signals can be identified:The optical fiber identifier is used for identifying 3 commonly used signal frequencies, namely 2KHz, 1KHz, 270Hz; when the frequency is recognized, it will beep
• Quick identification:The optical fiber identifier can quickly identifies the direction of transmitted fiber and display the relative core power without damaging the fiber or disrupting the network
• VFL:The bottom cover of the optical fiber identifier can be opened.VFL effectively cooperates with the optical fiber inspection
• Microbending test technology:The live optical fiber identifier can accurately identify fiber direction. When the optical fiber has a signal, the left and right direction lights indicate the signal direction. When the left direction light is on, it indicates that the light source is from right to left
• When holding the optical fiber identifier,Pull the back measurement switch. Clamp the optical fiber to automatically start the test. Press down to clamp the optcal fiber

• Fiber optic tool kit?Fiber optic tool bag, OPM, VFL, fiber optic cutter, cleaning paper, cleaning bottle, 3-port fiber optic stripping pliers, leather wire stripper, fiber optic scissors, FC-LC adapter, two in one fixed length device.
• Optical power meter?3-in-1 function, OPM/RJ45/LED power measurement range: -70~+10dbm, wavelength range: 800-1700nm, standard wavelength: 850/980/1270/1300/1310/1490/1550/1577/1625/1650 SC/FC/ST Universal Interface
• 30MW visual fault locator?Fiber optic red light pen VFL 2.5MM SC/FC/ST universal interface single mode Fiber Network Cable Test Output wavelength: 650nm 10nm
• 3 ports Fiber optic stripping pliers:Large caliber can be used for stripping 2mm-3mm Pigtail / jumper outer protective layer;Small caliber can be used for stripping 250um-125um Coating of optical fiber core.

• In the PON network, by extracting a small part of the optical signal online, the PON power meter can be car-ried out in the whole FTTx service opening, maintenance and detection stage, which can reliably verify and ensure to meet the requirements of network communication. It can test the optical power value of voice, data and video signals at the same time, and give the warning of exceeding the threshold. It is an ideal choice for engineering, construction and maintenance.
• Handheld PON optical power meter with LED lighting function, SC/FC interface adapter, supporting data storage and automatic calibration mode.
• Three wavelength tests: 1310nm, 1490nm, 1550nm, can be conducted simultaneously for three wavelengths, and the testing accuracy is controlled within 0.5dB.
• Dual port direct design: During testing, it can ensure full communication from OLT to ONT.
• Soft silicone shell design: Soft silicone protective cover to reduce losses caused by collisions and drops.