Trampoline Mold, Concrete Mold for Beginners, Reusable for Patio

By Brand : Sren

Avg Customer Reviews :

Specification:Item Type: Stepping Stone MoldMaterial: ABSColor: As Picture ShownApplication: for Garden, Pathway, Yard, LawnBottom: 38x28cm/15.0x11.0inTop: 33.5x25cm/13.2x9.8inHeight: 4cm/1.6inGross Weight: Approx.412g/14.5ozPackage List:1 x Stepping?Stone?MoldNote:Prepare molds: Before mixing concrete, make sure molds are clean and free of dirt. If used before, clean with soapy water. Just brush a little light vegetable oil or release on the form. Release agent is recommended, but not required. Not using a release agent makes it harder to release the stone, and you need to be more careful about damaging the mold. But too much release agent can cause bubbles on the .Mixed concrete:Always wear appropriate safety equipment (rubber gloves and particulate mask) when mixing concrete.Mixing can be done by hand in a bucket using an appropriate concrete mixer, a cart with a concrete hoe, or a shovel. It's very important to take the time to mix everything thoroughly.Tip: Adding coloring to the concrete will make the stepping stones look more natural and beautiful.Filling mold:Fill the bottom of the mold with concrete and pat vigorously to remove bubbles. Then fill the mold completely to the top and the top by hand so that the concrete is and even. Finish the mold by tapping and shaking to drain as many bubbles as possible. Curing and demoulding:When the mold is full, place the mold on a horizontal table. Cover with plastic film and wait less than 24 hours to cure. Plastic sheeting covered with concrete will help maintain humidity in the interior, like a greenhouse, which will minimize cracking. After the stone solidifies, it is then carefully pulled up gradually in all directions until it pops out.