Solar Equipment & Systems By amiciSmart

• Solar Charge Controller supports battery charging when connected between the battery and the solar panel. On the LCD display you can see the charging status and switch modes conveniently.
• With Overload protection, short circuit protection, open-circuit protection and reverse protection, the devincrease the battery life.
• amiciSmart Solar charge controller work with 12v and 24v panel, you can set float voltage (Float voltage is max battery charge voltage), discharge reconnect (Load on after this voltage), discharge stmode (When you set hours setting then load ON after sunset automatic).
• Suitable for lnot for nickel hydride, lithium, Li-ions, or other batteries. the device should be connected to the panel and battery both for the device to be working.
• Note:- When connecting the controller to the battery make sure that the battery should be atleast 10.7V charged. (Color may vary)

• Upgraded solar charge controller tSelect BAT1 for lead-acid battery, LIT1 for lithium tenary battery (3S/11.1V) and LIT2 for lithium iron phosphate battery (4S,12.8V).
• Solar charge controller comes with a big LCD display that can clearly indicate the status and data, it can be conveniently switched modes and parameter configuration
• Short-circuit protection, open-circuit protection, reverse protection, overload protection, more safety for using, suitable for home, industrial, commercial and more
• Solar panel suitable for solar power system, solar street lamp, smart home, solar light box, intelligent irrigation, camping lantern and more
• NOTE: For the product to be working it is important to connect the controller with panel and battery both. Also the battery should be more than 10.7 V charged. Output voltage depends on the battery type. If the battery voltage is 12V then output will be 12V only.