Splicing Systems By Hoseten

• Practical Kit: Including 3 types of fuse adapters, commonly suitable for 1Amp?30Amp blade fuses, compatible with 12 24V electrical systems.
fuse holder, and easy to install the additional circuits without splicing or cutting.
• High Quality Plastic Material: Made of high quality plastic material, with good conductivity and strong melting resistance.
• Wide Range of Applications: Suitable for car alarms, mobile phone chargers, GPS, DVD players, dash cam, etc.
• Warranty not applicable for this product

• The new MDD V1.2 is the simplest direct drive conversion available for Ender?3, for CR?10 3D printers.
• Lighter than most direct drives, installation takes about 20?30 minutes ? no firmware changes, no volume loss, no cutting or splicing.
• Simplest direct?drive system for printers. Practical accessory.
• There is no need to change the firmware when using extruder and hot ends, although we recommend starting with configuration file retracting 1.0mm and turning off the softening control (sliding, wiping, etc.).
• Warranty not applicable for this product