Water Management System - Water Level Controller Products

• Voltage: 250Vac Current: 15A Shape: Squarez
• Design Temperature: 80?C
• Cfls With 2 Meter Cable Length
• Product Colour May Slightly Vary Due To Photographic Lighting Sources Or Your Monitor Settings

• Six Nos. Of Sensors
• No Corrosion Sensor
• Compatible With All Water Level Controllers Models
• Material SS 316
• Easy To Fit And Use
• Can Have Capacity Up To 2.5 mm? Wire Fitting And Suitable For Tanks Upto 2000 Liters

• High switching capacity, strong anti-interference, features high stability.
• It also has a non-toxic, corrosion-resistant features.
• Small size, simple wiring, low power consumption.
• Easy to install, convenient to use, and long service life.
• The product can be widely used in water supply, drainage and liquid level automatic control with a variety of pump supporting.

• Float Water Level Controller WLC Square Head Float Switch Wired Sensor Security System Wired Sensor Security System
• INSTRUCTIONS, for INSTALLATION Insert the cable in the counter weight (yellow color part), from the conical part and rotate it. Thus causing the plastic ring inserted in the opening to become detached (if necessary this operation can be facilitated with the use of a screwdriver). The ring should then be positioned in the point where it is desired to block the counterweight. Force the counterweight on the ring by rotating it using a slight pressure
• Cable: 2 Meter (i.e. customize wire lenght is available)/ A float switch is a device used to detect the level of liquid within a tank. The switch may be used in a pump, an indicator, an alarm, or other devices & Use: Water Level, liquid level Controller etc,
• Instructions for use for the filling operation. Connect the blue control cable to the electric pump and the black wire to the neutral wire as shown in the picture to fill it with water (the brown wire must be waterproof). The electric pump begins to fill with water and when the water in the tank reaches a level stops working.
• Instructions for use for the emptying operation. For the draining operation connect the brown cable to the water pump and the black cable to a neutral cable, as shown in the picture (the blue cable must be insulated). The electric pump stops when the water level reaches a level and if it exceeds this level it starts again to expel water.

• Endurance: =500,000 times of wire and Plastic Body Electrical

• 1 Warranty : 1 Year Manufacturer. Warranty Service : Repair or Replacement
• 2 Electrolysis free design with 3 number carbon sensors having 1.5 meter wire length
• 3 fully automatic
• 4 auto bypass mode available
• 5 Premium blue enclosure

• Medium Size
• Water level controller board
• With dry run protection

• SUPPORTED TO SINGLE PHASE MONOBLOCK MOTOR
• SENSOR BASED DRY RUN PROTECTION
• AUTO DRY RESET 30 MINUTE, MANUAL RESET OPTION ALSO AVAILABLE
• SUPPORTED UPTO 3 HP
• DRY RUN CAN BE BYPASS

• WATERPROOF: Brandway canopy is water resistant as the roof is made of matty.
• PORTABLE: This canopy comes with a great carry bag. The canopy frame is foldable so it can be easily carried to different places.
• HEAVY DUTY FRAME: We provide Powder coated iron frame that is heavy duty and well built. For the longest use, keep away from water.
• UTILITY: One of the best ideas for promoting your brand and boosting sale is via canopy. 2-3 people can be comfortably seated inside.

• No man power is required as it is operate as fully automatic water level controller for tank, so dont worry about overflow.
• Water level indication provided to see water level in tank.
• Suitable to 0.1 HP to 2.0 HP Motor
• Also suitable for single phase MCB starter panel & submersible motor.
• Auto and Manual Mode Switch Provided
• Electrolysis Free Sensors, which means the sensors does not get Corrosive even after long time usage.

• VENEX Fully Automatic Water Level Controller and Indicator with 3 Sensor for Monoblock Motor (GREY) for Upper Tank SP LLC
• VENEX ELECTRICALS
• auto start and auto stop
• auto manual function
• 3 SS sensor

• Single Phase Digital Fully Automatic Water Level Controller For Municipality Water With All Types Of Protection
• Digital Display For Displaying Voltage And Ampere And Fault Of Your Motor
• Just Get This Product And Get Free From Headache Of Check And Start Motor At the Time Of Municipality Water Timing, As It Will Start The Motor Automatic By Detecting Municipality Water At Inlet Of The Motor
• Operating Voltage:-230 Volt and Support Up To 20 amps

• Suitable for any AC motor that are operated by simple switch/MCB (Single phase motor - Monoblock, Jet Pump, Submersible, etc.)
• Distance covers upto 1000 meters in line of sight and supports for 6 storey building/apartments. Unique ID helps to avoid data collision.
• Visual indication - Power ON, Motor ON, L/H voltage, RF Signal, Four water level indication. Corrosion free sensor
• No cabling is required between overhead tank (Transmitter) and controller (Receiver) unit.
• Advanced Embedded Technology. Long life. Easy to Install

• Can be Used With hydroponics, Salt water Tank, Fresh water tank, Gardening, aquariums for power head control, Pet bowls, fish tanks, filtration, RO , Water Coolers, Water Filters ,Dosing pumps etc.
• Features : Float Can Be Reversed For NO / NC By Opening Bottom Lock as Per Your Requirement / Contact : NO / NC
• Stem Material : PP Corrosion Free , Technology : Magnetic Advance Technology , Wire Length : 2 Meter ,
• Ideal Operating Ratings : Voltage: 2 to 50V DC .Current: 1amp / Max Current : 1.2A (DC), Max Switch Watt : 10W
• Switch Configuration : SPST , Float Ball Material: PP With excellent Acid and alkali / alkaline resistance , WIRE : Premium Tin Coated 14/40 Single Core For High Performance

• Power Supply: 180 to 245V, 50Hz, AC
• Sensing: Through corrosion resistance, solated 5V AC sensors or float sensor
• Output: 230V, 50Hz, AC for 1HP motor and capacitor connecting terminal for submersible pump. ( SSR is suggested in the input of 3 Phase or more then 1HP motor.
• Light weight, low in cost.
• Easy to install and operate.

• (1)Fully automatic water level controller with dry run protection single phase
• (2)Anti corrosion stainless sensor
• (3)Elecrolysis -Free Controller
• (4)NO Chemical Reaction Inside Water
• (5)Contact capacity : 20 A