Water Management System - Water Level Controller Products

• TIMER CONTROL & MANUAL ON/OFF : Water Overflow Controller with Timer with Manual ON and Auto Off : 1 Year Warranty.
• MULTIPLE TIMER OPTIONS : Peace of Mind with Timer Control which switches OFF Pump/Motor after pre-set time or Tank Full whichever is earlier (Options of 7.5, 15, 30, 60 Minutes to Switch OFF the Motor Automatically).
• HIGH QUALITY COMPONENTS : High Quality PCB, Circuit and Components, Stabilized Controlled Device (Consistent Performance of Device even in Electricity Fluctuations).
• KEY FEATURES : Tank Full Indication, Pump/Motor ON Indication, Power ON Indication, Push Button Switch to start the Pump/Motor (Suitable for Single Phase Motor).
• HEAVY DUTY : Powder Coated long lasting Metal Body, Quality Terminals to withstand heavy electrical load. Controller Suitable for Single Phase Pump/Motor upto 2HP.

• Single Phase Fully Automatic Water Level Controller For Municipality Water
• Anti Corrosion Stainless Steel Sensor
• Just Get This Product And Get Free From Headache Of Check And Start Motor At the Time Of Municipality Water Timing, As It Will Start The Motor Automatic By Detecting Municipality Water At Inlet Of The Motor
• Support Up to 3 H.P. Motor
• With Manual ON-Auto OFF, Fully automatic For Municipality Water

• Made from ABS plastic body,high grade PCB, for durability and performance.
• Overhead tank will have three sensors and ground level tank will have three sensors.
• Specially designed sensors that are plastic molded, corrosion resistant, non-conductive, low power, maintenance-free and safe for sensing levels in the tanks.
• System has three position power control toggle switch with "auto" mode, "off" mode and "manual" mode.
• Provide LED indication for Motor ON and OFF, water LOW and NORMAL.

• Includes a carrying case with belt clip.

• Indiacate level of tank
• Save Electricity
• Brust Free SS Sensor

• Easy to install in any tank just hang down and connect with on/off switch to cable, when tank full it go up (switch off) and when tank empty it's down (switch On).
• Long life & Rust proof (entire sensor body in polypropylene) High Quality Float switch with 3 mtr Cable.
• Contacts: NO+NC and Common
• Wier 3 Meter Rated voltage: 250V
• Electrical endurance: 500,000 times

• Tank Control - Double Tank/Overhead & Underground both.
• Motor Control - Single Phase/Monoblock Pump Motor operated by a normal on/off switch / MCB/ Electronic Starter.
• Load Capacity - 25 Amp & Upto 3 Hp Motor.
• Sensor - Corrosion Free, Stainless Steel-No current/Voltage is passed through Water, therefore No Electrolysis Salt Deposition in the sensor.
• HOUSING MATERIALS - Compact Steel with powder coated housing.

• VENEX 3 Phase Water Level Controller with DOL Digital Starter Suitable for Motor up to 10 HP with HV LV OL Dry Protection with spp
• fully automatic
• Warranty : 12 month Manufacturer. Warranty Service : Repair or Replacement. Package Contain : 1 Digital Starter with water level controller 6 S.S sensors 1 user manual
• This model is the combination of a digital water level controller and motor control panel (motor starter).
• with auto manual switch for bypass water level controller

• Control both tank underground tank to overhead tank fully automatically
• Work With Any Single Phase Motor For Home ,Office ,Hospital,Restaurant
• Auto-Switch: -Automatic switch for water level control. This controller will sense the water level in the tank and will turn on and off the water supply automatically.
• It requires no manpower to operate as it switches on the motor when tank level is low and automatically switcher it off when the tank full. It is very useful product for your daily life as it save your time water and electricity.
• Longer Life No Mechanical System /. Avoid Overflow
• Fully Automatic Controller, Micro Controller Based Design, Power Failure protection. (Not Start Motor Every Time on Power Failure. )
• No Men Power Required To Operate As Fully Automatic with 2HP capacity

• Floaty Water Level Controller WLC Square Head Float Switch Wired Sensor Security System Wired Sensor Security System
• Rated voltage: 250V & Rated current: 8A/Contacts: NO+NC & Weight
• Cable: 5 Meter (i.e. customize wire lenght is available)/ A float switch is a device used to detect the level of liquid within a tank. The switch may be used in a pump, an indicator, an alarm, or other devices & Use: Water Level, liquid level Controller etc,
• INSTRUCTIONS, for INSTALLATION Insert the cable in the counter weight (yellow color part), from the conical part and rotate it. Thus causing the plastic ring inserted in the opening to become detached (if necessary this operation can be facilitated with the use of a screwdriver). The ring should then be positioned in the point where it is desired to block the counterweight. Force the counterweight on the ring by rotating it using a slight pressure
• MADE IN INDIA PRODUCT

• Fully Automatic Controller, Micro Controller Based Design, Power Failure protection. (Not Start Motor Every Time on Power Failure. )
• When the water level in the tank becomes low, means water get down from middle sensor, motor get switch on automatically. The tank starts filling up. When the water level reaches to the higher level, the top level sensor sense. the motor automatically gets switched off
• Package Contain : 1 Water Level Controller Unit. 3 no S.S Sensors. 1 user manual with technical details
• Suitable to 0.1 HP to 2.0 HP Motor
• Auto and manual switch available

• Current Capacity - 3 Amp.
• Sensor Voltage - 12V DC (isolated)
• Dimension - L 60 X W 40 X H 87 mm
• Gross Weight - 0.250 kg. (approx.)

• Magnetic float type sensors are maintenance free.
• Long wire length makes sensors suitable for tanks with height upto 3.5 meters
• Different color sensor wires for different levels to avoid any kind of confusion
• These magnetic float sensors are made using high grade stainless steel pipe and Abs float for maintenance free operation
• Four magnetic sensors are required in case five conduction sensors are used.

• Protection from pump dry run
• Advanced micro controller based design
• Low Power Consumption
• High & Low voltage cut off
• Specialy designed for Indian climate
• Reliable brand Videon since 1985
• 1 year Warranty
• Spare parts availabilty post warranty

• MADE IN GERMANY : Normally open type high quality with advanced magnetic, reed switch technology float sensor with approx. 3 Meter wire length.
• ROHS, IP67 and REACH COMPLIANT : High quality polypropylene housing (Corrosion free). Lead free and comply with RoHS directive.
• NO SEPARATE ELECTRIC / POWER SOURCE REQUIRED : The sensor does not require any electric source and it works on the principle of Reed Switch and Magnet which help switching ON and OFF when the float moves up and Down.
• MECHANICAL SWITCH : It acts as a mechanical switch which is installed on top of a liquid surface and as the liquid level goes up and down it performs switching ON AND OFF.
• CAUTION : The sensor may get damaged if connected to electric current or higher load than specified.
• TECHNICAL SPECIFICATIONS : Switching Voltage Maximum = 200 VDC, Switching Voltage Maximum = 140 VAC, Carry Current Maximum = 500 mA (Ideal recommended 5 to 50 mA), Contact rating maximum = 10 W / VAC, Operating Temperature +10 to +50 Degree Celsius.
• SUITABILITY AND MOUNTING RECOMMENDATION: All types of Water Level Controllers, For Screw and Hanging Mount please refer to Images.

• Automatic Submersible Starter With Water Level Controller With inbuilt Running(36.mfd) Capacitor.
• Suitable for 0.5 To 0.75 HP/ Inbuilt Water-level Controller for Overhead and Underground Tank. / Auto & Manual Slide Switch Options.
• Low Voltage (130V), High Voltage (270V) & Overload Protection. [with Ampere Adjustable Knob]
• Tank Status (Empty / Filling) Indication's by LED's Provided on Controller./ High Voltage, Low Voltage and Overload State of Motor Indicated by LED's Provided on Controller.
• Why & What Is Run Capacitor? :- The Run Capacitor Is Inbuilt Provided In The Device. The Run Capacitor Provides Support To The Motor During Its Running Or Operational time And This Run Capacitor Is of 36.mfd, Therefore, It Can Operate on upto 0.5 To 0.75 Hp. Motor